HHLONIX
EN

Austria · A1

Can I use my own router with A1?

Partly. Gateway stays — use bridge/modem mode.

Network equipment and server rack
Illustrative photograph; equipment and compatibility may differ.Alan Levine · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

A1 Festnetz-Internet (DSL) — own router behind A1 WLAN Box in single-user mode

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
A1 WLAN Box (single-user/bridge) → Ethernet → own router
WAN connection
PPPoE
VLAN
Handled by provider device
ISP phone / voice
Keeps working on the provider hub
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Log in to the A1 WLAN Box at 10.0.0.138, open Wartung > WAN Profil Auswahl and switch to Single User (SU); this wipes the box settings and it reconnects within about 15 minutes.
  2. Cable your router's WAN port to one of the box's LAN1–4 ports (not the box's WAN port).
  3. On your router choose PPPoE as the WAN connection type (PPTP is also mentioned).
  4. Enter the 10-digit A1 user ID and password from your welcome letter, or request them from A1 if you no longer have them.
  5. Enable your router's firewall; to reach the box afterwards, give a PC the static address 10.0.0.1/24 with gateway 10.0.0.138.
Own-router pathGateway stays — use bridge/modem mode
WANPPPoE
PhoneKeeps working on the provider hub
TVCheck with your provider

What A1 officially documents

Log in to the A1 WLAN Box at 10.0.0.138, open Wartung > WAN Profil Auswahl and switch to Single User (SU); this wipes the box settings and it reconnects within about 15 minutes. Cable your router's WAN port to one of the box's LAN1–4 ports (not the box's WAN port). On your router choose PPPoE as the WAN connection type (PPTP is also mentioned). Enter the 10-digit A1 user ID and password from your welcome letter, or request them from A1 if you no longer have them. Enable your router's firewall; to reach the box afterwards, give a PC the static address 10.0.0.1/24 with gateway 10.0.0.138.

Before you remove the A1 box

Phone service keeps working on the provider device. TV services may use their own VLAN or box; check before swapping. Only the Zyxel VMG8623-T50B and DX3101-B0 boxes are covered; other models must be swapped via A1 support. Box Wi-Fi is disabled in single-user mode and only one device can be connected. Phone service keeps working through the box. A1 gives no support for own routers. VLAN, MTU, TV and fibre (FTTH) not stated. A1's business FAQ states the Business router itself cannot be replaced.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.