HHLONIX
EN

Brazil · Claro

Can I use my own router with Claro?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Mesh Wi-Fi router
Illustrative photograph; equipment and compatibility may differ.TaurusEmerald · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Claro (ex-NET) cable — Technicolor TC7337 in bridge mode

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
HFC cable modem (bridge mode) → Ethernet to own router
WAN connection
Handled by the cable modem
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Connect a computer by Ethernet to the Claro modem and log in to its web interface.
  2. Open the advanced settings, go to Network → Basic Settings, and change the Router option to Bridged; confirm.
  3. Wait about a minute; the modem's own address changes to 192.168.100.1.
  4. Connect your router's WAN port to the modem with Ethernet and leave the router's WAN on its automatic setting (router-side settings not stated by Claro).
Own-router pathGateway stays — use bridge/modem mode
WANHandled by the cable modem
PhoneCheck with your provider
TVCheck with your provider

What Claro officially documents

Connect a computer by Ethernet to the Claro modem and log in to its web interface. Open the advanced settings, go to Network → Basic Settings, and change the Router option to Bridged; confirm. Wait about a minute; the modem's own address changes to 192.168.100.1. Connect your router's WAN port to the modem with Ethernet and leave the router's WAN on its automatic setting (router-side settings not stated by Claro).

Before you remove the Claro box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Model-specific page (Technicolor TC7337); other Claro modems have similar pages on configuraraparelhos.claro.com.br. If 192.168.100.1 is unreachable you may need a static IP on the PC or a factory reset. Router-side WAN protocol and impact on Claro phone/TV: not stated. Claro fibre (GPON) own-router settings: not found officially.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.