HHLONIX
EN

Vietnam · FPT Telecom

Can I use my own router with FPT Telecom?

Yes. FPT Telecom documents PPPoE with a line-dependent VLAN with your account's broadband login.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Swpb · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

FPT Telecom fibre — PPPoE on own router (business guide)

Own-router path
Own router connects directly (medium-confidence evidence)
Physical handoff
Optical converter → Ethernet WAN
WAN connection
PPPoE
VLAN
Confirm with provider
ISP phone / voice
No dependency documented
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Connect the optical converter's LAN output to the router's WAN1 port.
  2. Set the WAN access mode to PPPoE and enable it.
  3. Enter the PPPoE username, password and MTU supplied for your FPT line, then save and restart.
  4. For FPT TV, enable IGMP proxy on the WAN facing the FPT line and IGMP snooping on the LAN.
WAN authPPPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What FPT Telecom officially documents

Connect the optical converter's LAN output to the router's WAN1 port. Set the WAN access mode to PPPoE and enable it. Enter the PPPoE username, password and MTU supplied for your FPT line, then save and restart. For FPT TV, enable IGMP proxy on the WAN facing the FPT line and IGMP snooping on the LAN.

Before you remove the FPT Telecom box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. FPT's official DrayTek Vigor 2927 guide is aimed at business users. MTU value, VLAN and where credentials come from are not stated; whether an FPT modem stays in bridge mode is not stated. Undated.

Common setup mistakes

Choose PPPoE, not Dynamic IP — the line will not come up with DHCP alone. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. IPTV: enable IGMP proxy/snooping on the WAN facing the FPT line Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.