Chile · VTR
Can I use my own router with VTR?
Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Quick reference
Own-router settings at a glance
From official provider sources cited below. Pick your router for a full verdict with topology and caveats.
VTR HFC cable — modem in bridge mode (via support)
- Own-router path
- Gateway stays — use bridge/modem mode
- Physical handoff
- HFC cable modem (bridge mode) → Ethernet to own router
- WAN connection
- Handled by the cable modem
- VLAN
- Handled by provider device
- ISP phone / voice
- Check with your provider
- ISP TV
- Check with your provider
- Evidence confidence
- Medium — verify account details
Settings to enter on your router
- Confirm you are an HFC (cable) customer — VTR says bridge mode is not available to fibre customers.
- Call VTR technical support (600 800 9000) and ask for the VTR equipment to be put in bridge mode.
- Connect an Ethernet cable from the VTR modem's LAN port to your router's WAN port.
- Leave your router's WAN on its automatic setting unless VTR tells you otherwise (the router-side connection type is not stated by VTR).
Instant verdict for your router:eero 6+Deco X50/X55ASUS RT-AX86U ProArcher BE550Orbi RBK760Nest Wifi ProOther router
Other Chilean ISPs:Compare all Chilean ISP settings
What VTR officially documents
Confirm you are an HFC (cable) customer — VTR says bridge mode is not available to fibre customers. Call VTR technical support (600 800 9000) and ask for the VTR equipment to be put in bridge mode. Connect an Ethernet cable from the VTR modem's LAN port to your router's WAN port. Leave your router's WAN on its automatic setting unless VTR tells you otherwise (the router-side connection type is not stated by VTR).
Before you remove the VTR box
The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. VTR fibre customers are explicitly excluded from bridge mode. Router-side WAN protocol, effects on telephony/TV: not stated.
Common setup mistakes
If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.
Next step
Evidence
Page reviewed 6 November 2026 · profile researched 6 November 2026.