HHLONIX
EN

Malaysia · Allo

Can I use my own router with Allo?

Yes. Depends on line authentication and router. Check phone and TV services before you remove the provider box.

Network equipment and server rack
Illustrative photograph; equipment and compatibility may differ.Alan Levine · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Allo Fibre — own router configured by authorised installer (paid)

Own-router path
Depends on line authentication and router
Physical handoff
Fibre ONT
WAN connection
Not published — ask the provider
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Ask Allo Careline whether your router model is suitable before switching.
  2. If you want help, book Allo's Authorised Installer to configure non-Allo equipment; this carries an extra charge paid directly to the installer.
  3. Have the installer or Careline confirm the WAN connection type and any VLAN for your line, since the official FAQ does not publish them.
Own-router pathDepends on line authentication and router
WANNot published — ask the provider
PhoneCheck with your provider
TVCheck with your provider

What Allo officially documents

Ask Allo Careline whether your router model is suitable before switching. If you want help, book Allo's Authorised Installer to configure non-Allo equipment; this carries an extra charge paid directly to the installer. Have the installer or Careline confirm the WAN connection type and any VLAN for your line, since the official FAQ does not publish them.

Before you remove the Allo box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Official FAQ confirms non-Allo equipment can be configured/supported by the Authorised Installer for an extra fee. WAN protocol, VLAN, MTU, credentials: not stated.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.