HHLONIX
EN

Malaysia · TIME

Can I use my own router with TIME?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Mesh Wi-Fi router
Illustrative photograph; equipment and compatibility may differ.TaurusEmerald · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

TIME Fibre — own router via PPPoE behind TIME device in bridge mode

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
TIME device in bridge mode → Ethernet WAN
WAN connection
PPPoE
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Contact TIME Customer Service and ask them to put your current TIME device into bridge mode.
  2. Log in to TIME Self Care and note your PPPoE username and password.
  3. Connect your own router's WAN/Internet port to the bridged TIME device.
  4. On your router, set the internet connection type to PPPoE and enter the Self Care username and password.
  5. Save and wait for the router to connect; TIME does not configure non-TIME equipment for you.
Own-router pathGateway stays — use bridge/modem mode
WANPPPoE
PhoneCheck with your provider
TVCheck with your provider

What TIME officially documents

Contact TIME Customer Service and ask them to put your current TIME device into bridge mode. Log in to TIME Self Care and note your PPPoE username and password. Connect your own router's WAN/Internet port to the bridged TIME device. On your router, set the internet connection type to PPPoE and enter the Self Care username and password. Save and wait for the router to connect; TIME does not configure non-TIME equipment for you.

Before you remove the TIME box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. TIME allows compatible third-party routers but customers must configure them themselves; no on-site support for non-TIME equipment. VLAN ID, MTU, IPv6: not stated (bridge mode on the TIME device is the documented path).

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.