HHLONIX
EN

International · Starlink

Can I use my own router with Starlink?

Partly. Gateway stays — use IP Passthrough.

An older Starlink router, not Router 3
Illustrative photograph; equipment and compatibility may differ.Tim Reckmann · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Starlink — Router 3 built-in Ethernet / Gen 2 adapter

Own-router path
Gateway stays — use IP Passthrough
Physical handoff
Starlink Router 3 Ethernet LAN (bypass mode), or Gen 2 router with Ethernet adapter
WAN connection
Handled by the provider gateway
VLAN
None — untagged
ISP phone / voice
No dependency documented
ISP TV
No dependency documented
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Starlink Router 3 (Gen 3) already has two built-in LAN Ethernet ports under the rear rubber cover. Do not buy a separate Ethernet adapter for Router 3.
  2. The Gen 2 Starlink router has no built-in LAN Ethernet port; use the official Starlink Ethernet adapter for a wired connection.
  3. Connect the third-party router's WAN port to a Router 3 LAN port, or to the Gen 2 Ethernet adapter.
  4. Enable bypass mode in the Starlink app. It disables the Starlink router's Wi-Fi, leaving your third-party router to manage your home network.
  5. Use the automatic WAN/IP setting unless your own service configuration requires otherwise; the cited bypass instructions do not specify a PPPoE login or VLAN ID.
  6. To restore Starlink router Wi-Fi after bypass, perform a factory reset; bypass cannot be turned off from the app.
Own-router pathGateway stays — use IP Passthrough
WANHandled by the provider gateway
PhoneNo dependency documented
TVNo dependency documented

What Starlink officially documents

Starlink Router 3 (Gen 3) already has two built-in LAN Ethernet ports under the rear rubber cover. Do not buy a separate Ethernet adapter for Router 3. The Gen 2 Starlink router has no built-in LAN Ethernet port; use the official Starlink Ethernet adapter for a wired connection. Connect the third-party router's WAN port to a Router 3 LAN port, or to the Gen 2 Ethernet adapter. Enable bypass mode in the Starlink app. It disables the Starlink router's Wi-Fi, leaving your third-party router to manage your home network. Use the automatic WAN/IP setting unless your own service configuration requires otherwise; the cited bypass instructions do not specify a PPPoE login or VLAN ID. To restore Starlink router Wi-Fi after bypass, perform a factory reset; bypass cannot be turned off from the app.

Before you remove the Starlink box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. Router 3 has two built-in LAN ports; the Ethernet adapter is for Gen 2, not Router 3. Starlink's official Ethernet-port and bypass-mode help articles document this difference. Router, power-supply and terminal generations vary; identify the exact kit before replacing hardware. IPv6/CGNAT details are not established by these particular instructions.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.