HHLONIX
EN

Norway · Telenor

Can I use my own router with Telenor?

Yes. Own router connects directly. Check phone and TV services before you remove the provider box.

Mesh Wi-Fi router
Illustrative photograph; equipment and compatibility may differ.Project Kei · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Telenor Norge fiber — own router allowed (IPTV needs IGMPv3)

Own-router path
Own router connects directly
Physical handoff
Fibre modem/ONT Ethernet → own router WAN
WAN connection
Not published — ask the provider
VLAN
None — untagged
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Connect your own router's WAN port to the Ethernet port of the Telenor fibre (or hybrid-fibre) modem.
  2. No VLAN configuration is needed for Telenor's IPTV service.
  3. If you use T-We over IPTV, enable IGMP proxy and IGMP snooping with IGMP version 3 on the router.
  4. Make sure any switches between router and TV box also support and have IGMP v3 enabled.
Own-router pathOwn router connects directly
WANNot published — ask the provider
PhoneCheck with your provider
TVCheck with your provider

What Telenor officially documents

Connect your own router's WAN port to the Ethernet port of the Telenor fibre (or hybrid-fibre) modem. No VLAN configuration is needed for Telenor's IPTV service. If you use T-We over IPTV, enable IGMP proxy and IGMP snooping with IGMP version 3 on the router. Make sure any switches between router and TV box also support and have IGMP v3 enabled.

Before you remove the Telenor box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Telenor states customers on fibre and hybrid-fibre do not have to use a Telenor router, but support for third-party gear is limited. WAN protocol (DHCP/PPPoE), MTU, IPv6, voice: not stated on the page.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.