HHLONIX
EN

Sweden · Telia

Can I use my own router with Telia?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Broadband router hardware
Illustrative photograph; equipment and compatibility may differ.TaurusEmerald · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Telia Sverige fiber — bridge the Telia router, own router on LAN 4

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
Fibre outlet/media converter → Telia router (bridged port) → own router
WAN connection
Handled by the provider gateway
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Browse to 192.168.1.1 on the Telia router and log in as Administrator with the access key from the router label.
  2. F1 / Technicolor DGA4330: Advanced interface → Bridge ETH port 4 → On → Save. Sagemcom Fast 5370e: Bridge Mode tab → On → Apply. TG799 models: Advanced interface → DMZ → On.
  3. Wait for the Telia router to restart (about 3–5 minutes).
  4. Connect your own router's WAN port to LAN 4 and leave its WAN on automatic.
  5. To undo, connect to ports 1–3 and switch the bridge/DMZ setting off.
Own-router pathGateway stays — use bridge/modem mode
WANHandled by the provider gateway
PhoneCheck with your provider
TVCheck with your provider

What Telia officially documents

Browse to 192.168.1.1 on the Telia router and log in as Administrator with the access key from the router label. F1 / Technicolor DGA4330: Advanced interface → Bridge ETH port 4 → On → Save. Sagemcom Fast 5370e: Bridge Mode tab → On → Apply. TG799 models: Advanced interface → DMZ → On. Wait for the Telia router to restart (about 3–5 minutes). Connect your own router's WAN port to LAN 4 and leave its WAN on automatic. To undo, connect to ports 1–3 and switch the bridge/DMZ setting off.

Before you remove the Telia box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Telia documents bridging its own router rather than replacing it. WAN protocol on the own router, VLAN, IPv6 and TV/telephony effects: not stated. TG799 'DMZ' mode is Telia's term for bridging port 4 on those models.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.