HHLONIX
EN

Denmark · YouSee

Can I use my own router with YouSee?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Mesh Wi-Fi router
Illustrative photograph; equipment and compatibility may differ.Project Kei · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

YouSee cable (Sagemcom F@st 3890) — bridge mode for own router

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
Coax → YouSee Sagemcom F@st 3890 in bridge mode → own router
WAN connection
Handled by the cable modem
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Browse to 192.168.0.1 and log in as admin with the Admin password printed on the Sagemcom router.
  2. Go to Avanceret → NAT Modes.
  3. Under Device Mode choose Bridge Mode and save.
  4. Connect your own router's WAN port to the Sagemcom and leave its WAN on automatic.
  5. To go back to router mode, reset the Sagemcom.
Own-router pathGateway stays — use bridge/modem mode
WANHandled by the cable modem
PhoneCheck with your provider
TVCheck with your provider

What YouSee officially documents

Browse to 192.168.0.1 and log in as admin with the Admin password printed on the Sagemcom router. Go to Avanceret → NAT Modes. Under Device Mode choose Bridge Mode and save. Connect your own router's WAN port to the Sagemcom and leave its WAN on automatic. To go back to router mode, reset the Sagemcom.

Before you remove the YouSee box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. YouSee publishes the guide but states it offers no support for bridge mode setup. Which port to use, WAN protocol, IPv6 and TV/telephony effects: not stated. Fibre own-router page not found.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.