HHLONIX
EN

France · Bouygues Telecom

Can I use my own router with Bouygues Telecom?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Broadband router hardware
Illustrative photograph; equipment and compatibility may differ.TaurusEmerald · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Bouygues Bbox — own router behind Bbox in bridge mode

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
Bbox (bridge mode) → Ethernet → own router
WAN connection
Handled by the provider gateway
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Keep the Bbox connected to the line; replacing it is not described by Bouygues.
  2. In the Bbox admin interface switch the box to bridge mode (Bouygues has a dedicated 'configurer mode bridge' assistance article) so it stops doing NAT.
  3. Connect your router to the Bbox by Ethernet and let it manage the home network.
  4. Alternative if you only want better Wi-Fi: set your router to access-point mode and disable its DHCP server.
Own-router pathGateway stays — use bridge/modem mode
WANHandled by the provider gateway
PhoneCheck with your provider
TVCheck with your provider

What Bouygues Telecom officially documents

Keep the Bbox connected to the line; replacing it is not described by Bouygues. In the Bbox admin interface switch the box to bridge mode (Bouygues has a dedicated 'configurer mode bridge' assistance article) so it stops doing NAT. Connect your router to the Bbox by Ethernet and let it manage the home network. Alternative if you only want better Wi-Fi: set your router to access-point mode and disable its DHCP server.

Before you remove the Bouygues Telecom box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Source is Bouygues' own guide on double NAT; it recommends bridge mode for box + personal router and mentions DMZ as a less recommended option. Router WAN protocol, VLAN, IPv6, TV/voice impact and supported Bbox models are not stated on the page fetched. The detailed bridge-mode assistance article could not be fetched.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.