HHLONIX
EN

Hong Kong · Netvigator (HKT)

Can I use my own router with Netvigator (HKT)?

Yes. Netvigator (HKT) documents PPPoE with a line-dependent VLAN with your account's broadband login. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Marcnovac · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Netvigator broadband — PPPoE login

Own-router path
Own router connects directly (medium-confidence evidence)
Physical handoff
Provider modem/ONT → Ethernet WAN
WAN connection
PPPoE
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Connect the Netvigator modem's Ethernet output to your router's WAN port.
  2. Set the WAN connection type to PPPoE.
  3. Enter your Netvigator login in the form loginID@netvigator.com and your account password.
  4. Save and reconnect; if you get errors 691/678, recheck the login name/password and power-cycle the modem for about 15 seconds.
WAN authPPPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Netvigator (HKT) officially documents

Connect the Netvigator modem's Ethernet output to your router's WAN port. Set the WAN connection type to PPPoE. Enter your Netvigator login in the form loginID@netvigator.com and your account password. Save and reconnect; if you get errors 691/678, recheck the login name/password and power-cycle the modem for about 15 seconds.

Before you remove the Netvigator (HKT) box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Official page documents a PPPoE broadband login (written for Windows dial-up setup), with username format loginID@netvigator.com. It does not say which access technology (fibre vs DSL), nor where customers find the login, nor VLAN/MTU. No explicit statement on third-party routers. Undated.

Common setup mistakes

Choose PPPoE, not Dynamic IP — the line will not come up with DHCP alone. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.