HHLONIX
EN

Singapore · WhizComms

Can I use my own router with WhizComms?

Only behind the provider device. Provider modem stays in front of your router.

Network equipment and server rack
Illustrative photograph; equipment and compatibility may differ.Shixart1985 · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

WhizComms Fibre — keep ONR, own router in Access Point mode

Own-router path
Provider modem stays in front of your router
Physical handoff
WhizComms ONR (router) → own router as AP
WAN connection
Handled by the provider gateway
VLAN
Handled by provider device
ISP phone / voice
No dependency documented
ISP TV
No dependency documented
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Keep the WhizComms ONR connected as the main router; it holds the public WAN IP.
  2. Connect your own router to an ONR LAN port (on 10Gbps plans, use the ONR 10G LAN port).
  3. Set your own router to Access Point (AP) mode so it does not double-NAT behind the ONR's 192.168.10.x network.
  4. Configure Wi-Fi on your own router; leave routing, DHCP and the WAN connection to the ONR.
Own-router pathProvider modem stays in front of your router
WANHandled by the provider gateway
PhoneNo dependency documented
TVNo dependency documented

What WhizComms officially documents

Keep the WhizComms ONR connected as the main router; it holds the public WAN IP. Connect your own router to an ONR LAN port (on 10Gbps plans, use the ONR 10G LAN port). Set your own router to Access Point (AP) mode so it does not double-NAT behind the ONR's 192.168.10.x network. Configure Wi-Fi on your own router; leave routing, DHCP and the WAN connection to the ONR.

Before you remove the WhizComms box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. Official FAQ says any third-party router is compatible but recommends AP mode behind the ONR. No IPv6 currently. Port forwarding/DDNS not supported on standard plans. WAN protocol/VLAN for replacing the ONR: not stated.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.