HHLONIX
EN

Germany · Deutsche Glasfaser

Can I use my own router with Deutsche Glasfaser?

Yes. Deutsche Glasfaser documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Network equipment and server rack
Illustrative photograph; equipment and compatibility may differ.Shixart1985 · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Deutsche Glasfaser FTTH — own router on NT LAN port 1 (DHCP)

Own-router path
Own router connects directly
Physical handoff
Fibre NT (Glasfaser-Modem) LAN 1 → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Plug your router's WAN (or a LAN-as-WAN) port into LAN port 1 of the Deutsche Glasfaser NT — ports 2–4 are disabled.
  2. Set the internet connection type to DHCP / obtain IP automatically; no PPPoE login is used.
  3. On a FRITZ!Box choose 'Weitere Internetanbieter → Deutsche Glasfaser' and allow 8–10 minutes for automatic provisioning.
  4. For telephony, add a SIP account with registrar dg.voip.dg-w.de and the SIP username/password from your order/installation confirmation.
  5. Enable IPv6 support on the router (the older Genexis manual names IPv6rd/dual stack).
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Deutsche Glasfaser officially documents

Plug your router's WAN (or a LAN-as-WAN) port into LAN port 1 of the Deutsche Glasfaser NT — ports 2–4 are disabled. Set the internet connection type to DHCP / obtain IP automatically; no PPPoE login is used. On a FRITZ!Box choose 'Weitere Internetanbieter → Deutsche Glasfaser' and allow 8–10 minutes for automatic provisioning. For telephony, add a SIP account with registrar dg.voip.dg-w.de and the SIP username/password from your order/installation confirmation. Enable IPv6 support on the router (the older Genexis manual names IPv6rd/dual stack).

Before you remove the Deutsche Glasfaser box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. No VLAN is mentioned in either official manual. Genexis NT manual is © 2015 (IPv6rd may be outdated — current networks use DS-Lite/CGNAT per many reports, not confirmed officially here). FRITZ!Box handbook © 2021. SIP codecs G.711; credentials in 'SIP-Account-Daten' of the confirmation letter.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Router must be a DHCP client; Genexis NT manual (2015) lists IPv6rd and IPv4/IPv6 dual stack support as requirements. SIP registrar: dg.voip.dg-w.de. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.