HHLONIX
EN

Italy · Iliad

Can I use my own router with Iliad?

Yes. Iliad documents DHCP / IPoE with a line-dependent VLAN with your account's broadband login. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Santeri Viinamäki · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Iliad Fibra senza iliadbox — own router (IPv6-native)

Own-router path
Depends on line authentication and router
Physical handoff
Fibre (EPON or GPON) → own router
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
No dependency documented
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Subscribe to the 'fibra senza iliadbox' offer; Iliad does not replace or support customer routers.
  2. Configure the WAN for native IPv6 using SLAAC plus DHCPv6.
  3. Set up the IPv4-in-IPv6 tunnel (RFC 2473) that Iliad uses for IPv4 — follow Iliad's official Turris Omnia or MikroTik RB4011 guides linked from the offer page.
  4. Configure VoIP with G.711 A-law / G.729, 20 ms, RFC 2833 DTMF, VAD off.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Iliad officially documents

Subscribe to the 'fibra senza iliadbox' offer; Iliad does not replace or support customer routers. Configure the WAN for native IPv6 using SLAAC plus DHCPv6. Set up the IPv4-in-IPv6 tunnel (RFC 2473) that Iliad uses for IPv4 — follow Iliad's official Turris Omnia or MikroTik RB4011 guides linked from the offer page. Configure VoIP with G.711 A-law / G.729, 20 ms, RFC 2833 DTMF, VAD off.

Before you remove the Iliad box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. VLAN, MTU, ONT/EPON module requirements and tunnel endpoint not stated on the reachable official pages. Tested routers: Turris Omnia 2020, MikroTik RB4011iGS. Iliad Wi-Fi extender not supported. Transparency sheet dated 30.12.2025.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Native IPv6 via autoconfiguration + DHCPv6; IPv4 delivered through an RFC 2473 IPv6 tunnel (tunnel type/parameters not stated on page). Static public IPv4 and IPv6 per technical transparency sheet. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.