HHLONIX
EN

Italy · Sky Wifi

Can I use my own router with Sky Wifi?

Yes. Sky Wifi documents DHCP / IPoE on VLAN 101. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Santeri Viinamäki · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Sky Wifi FTTH — own router with MAP-T

Own-router path
Depends on line authentication and router
Physical handoff
Fibre ONT → Ethernet WAN
WAN connection
DHCP
VLAN
VLAN 101 (802.1Q tagged)
ISP phone / voice
Check with your provider
ISP TV
No dependency documented
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Connect the router WAN to the ONT's Gigabit RJ-45 port.
  2. Set WAN to IPoE (no PPPoE login) with IPv6 enabled.
  3. Tag VLAN 101 with 802.1p priority 5 (FTTH).
  4. Enable MAP-T (RFC 7599) for IPv4 — the router must support it.
  5. For phone service, request SIP username/password with your Sky iD; SIP domain voip.sky.it, outbound proxy voip.it.isp.sky.
WAN authDHCP / IPoE
VLAN101 (802.1Q tagged)
Priority / PCP5
MTUDefault

What Sky Wifi officially documents

Connect the router WAN to the ONT's Gigabit RJ-45 port. Set WAN to IPoE (no PPPoE login) with IPv6 enabled. Tag VLAN 101 with 802.1p priority 5 (FTTH). Enable MAP-T (RFC 7599) for IPv4 — the router must support it. For phone service, request SIP username/password with your Sky iD; SIP domain voip.sky.it, outbound proxy voip.it.isp.sky.

Before you remove the Sky Wifi box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. No PPPoE credentials (IPoE). MTU, DHCP specifics and MAP-T rule parameters not stated; Sky refers these to the router vendor. Page shows no update date. IPv4 runs over MAP-T, so the router must support MAP-T.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. Tag the WAN with VLAN 101 and priority 5; a missing or wrong tag is the most common reason a new router gets no connection. IPoE dual-stack; IPv4 via MAP-T (RFC 7599, translation mode). FTTC uses the same VLAN 101 with PCP 3. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.