HHLONIX
EN

Canada · Cogeco

Can I use my own router with Cogeco?

Partly. Gateway stays — use bridge/modem mode. Check phone and TV services before you remove the provider box.

Mesh Wi-Fi router
Illustrative photograph; equipment and compatibility may differ.homethods.com · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Cogeco Internet — own router behind Cogeco modem in bridge mode

Own-router path
Gateway stays — use bridge/modem mode
Physical handoff
Coax → Cogeco modem (bridge mode) → your router
WAN connection
Handled by the cable modem
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Provider hub required
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Contact Cogeco technical support and ask them to put your Cogeco modem into bridge mode.
  2. Connect the modem's Ethernet port to your router's WAN port.
  3. Set the router's WAN connection type to DHCP / automatic IP.
  4. Note bridge mode is not available if you have TiVo or Cogeco Wi-Fi Pods/extenders.

Cogeco (Express help centre areas) — no own modem; own router via DHCP

Own-router path
Provider modem stays in front of your router
Physical handoff
Cogeco-certified modem/router → your router WAN (Ethernet)
WAN connection
DHCP
VLAN
Handled by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Keep the Cogeco-supplied modem — Cogeco states you cannot use your own modem in these areas.
  2. Connect the modem's Ethernet cable to your router's WAN port.
  3. Set your router's internet connection to DHCP.
  4. Alternatively use your router as an access point on a Cogeco LAN port with its own DHCP server turned off.
Own-router pathGateway stays — use bridge/modem mode
WANHandled by the cable modem
PhoneCheck with your provider
TVProvider hub required

What Cogeco officially documents

Contact Cogeco technical support and ask them to put your Cogeco modem into bridge mode. Connect the modem's Ethernet port to your router's WAN port. Set the router's WAN connection type to DHCP / automatic IP. Note bridge mode is not available if you have TiVo or Cogeco Wi-Fi Pods/extenders. Keep the Cogeco-supplied modem — Cogeco states you cannot use your own modem in these areas. Connect the modem's Ethernet cable to your router's WAN port. Set your router's internet connection to DHCP. Alternatively use your router as an access point on a Cogeco LAN port with its own DHCP server turned off.

Before you remove the Cogeco box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV needs the provider device. Cogeco allows third-party routers but does not recommend them. Customer-owned modems are not covered by the main article; Cogeco's Express help centre states own modems cannot be used there (only line-provider-certified modems). WAN 'dhcp' for the router is per the Express article; the main article does not state it.

Common setup mistakes

If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.