HHLONIX
EN

Canada · Execulink

Can I use my own router with Execulink?

Yes. Execulink documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Amin · CC BY-SA 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Execulink Fibre — own router in DHCP mode

Own-router path
Own router connects directly
Physical handoff
Fibre ONT → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Make sure your router has a 5 GHz WiFi network.
  2. Set the router's internet/WAN connection to DHCP (automatic).
  3. Connect the router's WAN port to the fibre ONT.
  4. Have the router's admin username and password ready for the installer, who uses them to connect any TV set-top boxes.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Execulink officially documents

Make sure your router has a 5 GHz WiFi network. Set the router's internet/WAN connection to DHCP (automatic). Connect the router's WAN port to the fibre ONT. Have the router's admin username and password ready for the installer, who uses them to connect any TV set-top boxes.

Before you remove the Execulink box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. If you cannot meet all three requirements Execulink recommends renting its router. ONT port, VLAN and phone impact not stated. Support: (866) 706-1994.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Router must be in DHCP mode and offer 5 GHz WiFi; give the technician your router admin login so set-top boxes can be connected. VLAN not stated. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.