Canada · Start.ca
Can I use my own router with Start.ca?
Yes. Own router connects directly. Check phone and TV services before you remove the provider box.

Quick reference
Own-router settings at a glance
From official provider sources cited below. Pick your router for a full verdict with topology and caveats.
Start.ca Fibre — your gigabit router on the supplied ONT
- Own-router path
- Own router connects directly
- Physical handoff
- Start.ca fibre modem (ONT) → Ethernet WAN
- WAN connection
- Not published — ask the provider
- VLAN
- Confirm with provider
- ISP phone / voice
- Check with your provider
- ISP TV
- Check with your provider
- Evidence confidence
- Medium — verify account details
Settings to enter on your router
- Use a router that handles gigabit speeds and has a WAN port.
- Connect the router's WAN port to the Start.ca fibre modem (ONT) with an Ethernet cable.
- Leave the router WAN on its default automatic setting; Start.ca does not publish PPPoE/VLAN values.
- If you have your router ready at installation, the technician can connect it for you; otherwise call support for help.
Instant verdict for your router:eero 6+Deco X50/X55ASUS RT-AX86U ProArcher BE550Orbi RBK760Nest Wifi ProOther router
Other Canadian ISPs:RogersTELUSCogecoShaw (Rogers)TekSavvyExeculinkCompare all Canadian ISP settings
What Start.ca officially documents
Use a router that handles gigabit speeds and has a WAN port. Connect the router's WAN port to the Start.ca fibre modem (ONT) with an Ethernet cable. Leave the router WAN on its default automatic setting; Start.ca does not publish PPPoE/VLAN values. If you have your router ready at installation, the technician can connect it for you; otherwise call support for help.
Before you remove the Start.ca box
The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. FAQs describe this as simply plugging the router into the fibre modem, but the WAN protocol is not stated. Cable/DSL own-modem rules not covered by these pages.
Common setup mistakes
If the provider device must stay, put your own router behind it and avoid double NAT: use the provider's bridge, modem or passthrough option where one exists, otherwise run your router in access-point mode.
Next step
Evidence
- Start.ca — What kind of router do I need? (official FAQ) (official ISP)
- Start.ca — Will I need a special modem? (official FAQ) (official ISP)
- Start.ca — Will the installation technician connect my fibre modem to my router? (official FAQ) (official ISP)
Page reviewed 6 November 2026 · profile researched 6 November 2026.