HHLONIX
EN

United Kingdom · Community Fibre

Can I use my own router with Community Fibre?

Yes. Community Fibre documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Fibre-optic broadband infrastructure
Illustrative photograph; equipment and compatibility may differ.Profpcde · CC0 1.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Community Fibre — own router via DHCP

Own-router path
Own router connects directly
Physical handoff
Fibre ONT → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
No dependency documented
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Use a router with an RJ45 (Ethernet) WAN port rated for your package speed.
  2. Connect the router WAN port to the Community Fibre fibre box.
  3. Set the WAN connection type to DHCP / automatic IP — Community Fibre does not use PPPoE, so no login is needed.
  4. Save and reboot; keep the supplied router in case support asks you to reconnect it for line testing.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Community Fibre officially documents

Use a router with an RJ45 (Ethernet) WAN port rated for your package speed. Connect the router WAN port to the Community Fibre fibre box. Set the WAN connection type to DHCP / automatic IP — Community Fibre does not use PPPoE, so no login is needed. Save and reboot; keep the supplied router in case support asks you to reconnect it for line testing.

Before you remove the Community Fibre box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. Own routers are explicitly allowed. VLAN, MTU and voice handling are not stated on the page. Support may ask you to swap back to a Community Fibre router when troubleshooting. No page date shown.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.