HHLONIX
EN

United Kingdom · Gigaclear

Can I use my own router with Gigaclear?

Yes. Gigaclear documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Networking installation tools
Illustrative photograph; equipment and compatibility may differ.www.heimnetzwerke.net · CC BY 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Gigaclear — own router via DHCP (some ONTs need bridge mode first)

Own-router path
Depends on line authentication and router
Physical handoff
Fibre ONT (wall-mounted fibre box) → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
No dependency documented
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Check which fibre box you have: if it is a Genexis unit, ask Gigaclear Customer Operations to put it into bridge mode first; DKT and Adtran boxes need no change.
  2. Use a router with a Gigabit WAN port that supports IPv4 and a dynamically assigned WAN address.
  3. Move the Ethernet cable from the Linksys router to your router's WAN port.
  4. Set the WAN connection to DHCP / obtain an IP address automatically.
  5. Save and reboot the router.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Gigaclear officially documents

Check which fibre box you have: if it is a Genexis unit, ask Gigaclear Customer Operations to put it into bridge mode first; DKT and Adtran boxes need no change. Use a router with a Gigabit WAN port that supports IPv4 and a dynamically assigned WAN address. Move the Ethernet cable from the Linksys router to your router's WAN port. Set the WAN connection to DHCP / obtain an IP address automatically. Save and reboot the router.

Before you remove the Gigaclear box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. From Gigaclear's official home networking guide (PDF, no date/version shown). VLAN and MTU not stated. Gigaclear does not support router-specific problems on customer equipment. The guide does not say how own routers affect Home Phone.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Genexis ONTs must be switched to bridge mode by Gigaclear first Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.