HHLONIX
EN

United Kingdom · YouFibre

Can I use my own router with YouFibre?

Yes. YouFibre documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Fibre-optic broadband infrastructure
Illustrative photograph; equipment and compatibility may differ.Profpcde · CC0 1.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

YouFibre — own router via DHCP

Own-router path
Own router connects directly
Physical handoff
Fibre ONT → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
No dependency documented
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Make sure your router has an Ethernet WAN port.
  2. Plug the router WAN port into the YouFibre ONT (the fibre box stays in place).
  3. Set the WAN connection type to DHCP / automatic IP.
  4. Save and reboot the router.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What YouFibre officially documents

Make sure your router has an Ethernet WAN port. Plug the router WAN port into the YouFibre ONT (the fibre box stays in place). Set the WAN connection type to DHCP / automatic IP. Save and reboot the router.

Before you remove the YouFibre box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. No TV dependency is documented. Own routers are explicitly allowed. VLAN, MTU, credentials and voice handling are not stated. No page date shown. brsk router guides are now hosted on YouFibre's knowledge base, but no brsk-specific own-router settings were found.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.