HHLONIX
EN

Australia · Belong

Can I use my own router with Belong?

Yes. Belong documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Networking installation tools
Illustrative photograph; equipment and compatibility may differ.www.heimnetzwerke.net · CC BY 4.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Belong nbn FTTP / FTTC / HFC — own modem

Own-router path
Own router connects directly
Physical handoff
nbn connection box (NTD) → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Connect the modem's WAN port to the nbn connection box with a Cat5e or better cable (FTTN/FTTB: DSL port to the phone socket with an RJ11 cable).
  2. Set the internet connection to IPoE (Dynamic IP / DHCP); change it if your modem defaults to PPPoE.
  3. VLAN, MTU and login values are not listed on Belong's page; leave defaults or call 1300 235 664.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Belong officially documents

Connect the modem's WAN port to the nbn connection box with a Cat5e or better cable (FTTN/FTTB: DSL port to the phone socket with an RJ11 cable). Set the internet connection to IPoE (Dynamic IP / DHCP); change it if your modem defaults to PPPoE. VLAN, MTU and login values are not listed on Belong's page; leave defaults or call 1300 235 664.

Before you remove the Belong box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Belong states its nbn connections use IPoE. VLAN, MTU, credentials and VoIP not stated. No page date.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.