HHLONIX
EN

Australia · Leaptel

Can I use my own router with Leaptel?

Yes. Leaptel documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Tony Webster · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

Leaptel nbn FTTP / HFC / FTTC / Fixed Wireless — own router

Own-router path
Own router connects directly
Physical handoff
nbn connection box (NTD) → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
Medium — verify account details

Settings to enter on your router

  1. Use a router with an Ethernet WAN port and connect it to the nbn connection box (FTTN/FTTB: VDSL modem-router).
  2. Set the WAN to IPoE / DHCP (Dynamic IP) — Leaptel's primary method.
  3. If IPoE does not work, PPPoE is the secondary option.
  4. Some TP-Link/Netgear VDSL models must be put in wireless router mode to use Ethernet WAN.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What Leaptel officially documents

Use a router with an Ethernet WAN port and connect it to the nbn connection box (FTTN/FTTB: VDSL modem-router). Set the WAN to IPoE / DHCP (Dynamic IP) — Leaptel's primary method. If IPoE does not work, PPPoE is the secondary option. Some TP-Link/Netgear VDSL models must be put in wireless router mode to use Ethernet WAN.

Before you remove the Leaptel box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. VLAN, MTU, credentials not stated. Opticomm HFC and Lynham Networks are PPPoE only; some Opticomm FTTP/FTTB sites PPPoE only. Locked ISP modems and the TPG Huawei HG659 are listed as incompatible. No page date.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. PPPoE available as secondary option Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.