HHLONIX
EN

Australia · More

Can I use my own router with More?

Yes. More documents DHCP / IPoE with a line-dependent VLAN. Check phone and TV services before you remove the provider box.

Ethernet cable and network connections
Illustrative photograph; equipment and compatibility may differ.Ajay Suresh · CC BY 2.0 · Wikimedia Commons
Page reviewed 6 November 2026Profile researched 6 November 2026Cited sources 1How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

More nbn FTTP / FTTC — own router

Own-router path
Own router connects directly
Physical handoff
nbn connection box (NTD) → Ethernet WAN
WAN connection
DHCP
VLAN
Confirm with provider
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Connect the router's WAN port to the nbn connection box and set it to WAN mode.
  2. Set encapsulation to IPoE.
  3. If the service was activated before 2 June 2025, use PPPoE with your ISP username and password instead.
WAN authDHCP / IPoE
VLANVaries — confirm for your line
Priority / PCP—
MTUDefault

What More officially documents

Connect the router's WAN port to the nbn connection box and set it to WAN mode. Set encapsulation to IPoE. If the service was activated before 2 June 2025, use PPPoE with your ISP username and password instead.

Before you remove the More box

The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. VLAN and MTU not stated. More nbn phone needs a VoIP-capable device. No page date.

Common setup mistakes

Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. Services activated before 02/06/25 use PPPoE with account username/password Power-cycle the ONT or modem after swapping routers so it releases the old session.

Next step

Evidence

Page reviewed 6 November 2026 · profile researched 6 November 2026.