Australia · MATE
Can I use my own router with MATE?
Yes. MATE documents DHCP / IPoE with a line-dependent VLAN with your account's broadband login. Check phone and TV services before you remove the provider box.
.jpg/960px-Ethernet_Port_(49790583026).jpg)
Quick reference
Own-router settings at a glance
From official provider sources cited below. Pick your router for a full verdict with topology and caveats.
MATE nbn FTTP / HFC / FTTC / Fixed Wireless — own router
- Own-router path
- Own router connects directly (medium-confidence evidence)
- Physical handoff
- nbn connection box (NTD) → Ethernet WAN
- WAN connection
- DHCP
- VLAN
- Confirm with provider
- ISP phone / voice
- Check with your provider
- ISP TV
- Check with your provider
- Evidence confidence
- Medium — verify account details
Settings to enter on your router
- Connect the router's WAN port to the nbn connection box and set the access type to Ethernet WAN.
- Try IPoE / Dynamic IP first after a factory reset.
- If IPoE does not connect, switch to PPPoE and enter the username and password from your MATE welcome emails.
- Enable IPv6 if supported, using DHCPv6 or SLAAC.
Instant verdict for your router:eero 6+Deco X50/X55ASUS RT-AX86U ProArcher BE550Orbi RBK760Nest Wifi ProOther router
Other Australian ISPs:TelstraAussie BroadbandOptusTPGiiNetInternodeVodafone AustraliaLeaptelDodoBelongOriginSwoopTangerineSpinTelMoreCompare all Australian ISP settings
What MATE officially documents
Connect the router's WAN port to the nbn connection box and set the access type to Ethernet WAN. Try IPoE / Dynamic IP first after a factory reset. If IPoE does not connect, switch to PPPoE and enter the username and password from your MATE welcome emails. Enable IPv6 if supported, using DHCPv6 or SLAAC.
Before you remove the MATE box
The official page does not settle phone service for a third-party router — confirm before you disconnect the provider box. TV services may use their own VLAN or box; check before swapping. Official pages disagree on order: the FAQ (29 Jul 2025) says start with IPoE, while the FTTP guide (27 Nov 2025) labels PPPoE as preferred. VLAN and MTU not stated.
Common setup mistakes
Choose Dynamic IP / DHCP (IPoE), not PPPoE — there is no broadband login to enter. The VLAN depends on the access network behind your line — confirm it with the provider before configuring the router. PPPoE alternative; IPv6 via DHCPv6 or SLAAC Power-cycle the ONT or modem after swapping routers so it releases the old session.
Next step
Evidence
- MATE — How do I configure my BYO modem/router? (official FAQ, modified 29 Jul 2025) (official ISP)
- MATE — nbn FTTP BYO modem/router setup guide (official, modified 27 Nov 2025) (official ISP)
Page reviewed 6 November 2026 · profile researched 6 November 2026.