HHLONIX
EN

United States · AT&T

Can I replace the AT&T Fiber gateway with my own router?

For the supported Hlonix path, no: keep the AT&T gateway and place your router behind it using IP Passthrough. AT&T documents the gateway as the equipment that provides the connection to AT&T Fiber and separately documents IP Passthrough for third-party networking equipment.

Fibre-optic broadband infrastructure
Illustrative photograph; equipment and compatibility may differ.Ranch9613 · CC0 1.0 · Wikimedia Commons
Page reviewed 28 September 2026Dataset snapshot 23 September 2026Cited sources 2How Hlonix verifies →

Quick reference

Own-router settings at a glance

From official provider sources cited below. Pick your router for a full verdict with topology and caveats.

AT&T Fiber — supplied BGW gateway + own router

Own-router path
Gateway stays — use IP Passthrough
Physical handoff
AT&T Fiber through supplied Wi-Fi gateway
WAN connection
Managed by the provider gateway
VLAN
Managed by provider device
ISP phone / voice
Check with your provider
ISP TV
Check with your provider
Evidence confidence
High — official provider source

Settings to enter on your router

  1. Keep the AT&T Wi-Fi gateway in the path.
  2. On BGW210/BGW320, configure IP Passthrough and use DHCPS-fixed for the third-party router MAC address.
  3. Let the third-party router handle your LAN/Wi-Fi while the AT&T gateway remains the provider access device.
Provider gatewayStays in the path
Third-party routerRuns behind IP Passthrough
BGW210 / BGW320DHCPS-fixed passthrough documented
Full gateway removalNot the supported Hlonix verdict

What IP Passthrough changes

The AT&T gateway still terminates the provider service, but one downstream device receives the gateway's WAN address. Your own router can then own the home LAN, Wi-Fi, firewall rules and port forwards.

Why this is not bridge mode

AT&T describes IP Passthrough as an alternative to bridged mode. The gateway remains active, so Hlonix labels this as 'gateway stays' instead of pretending it is a direct ONT-to-router replacement.

Before changing the setup

Record the current gateway configuration, connect your router by Ethernet, use the documented passthrough mode for its WAN MAC address, and keep the AT&T gateway accessible for diagnostics.

Next step

Evidence

Page reviewed 28 September 2026 · compatibility dataset snapshot 23 September 2026.